Moultrie Welder MFHP81565 User Manual

Instructions for Econo Plus Feeder Kit  
THANK YOU for your purchase of the Econo Plus Feeder Kit.  
Please read this sheet before operating the unit. If you should have  
any questions about this product or any other Moultrie product,  
please contact us using the information below. To help us to better  
serve you, please complete and mail the enclosed Warranty Card.  
DRILLING YOUR DRUM/BARREL/BUCKET  
Funnel Holes  
Econo Plus Feeder will mount to the bottom of any drum or bucket  
caution: wear eye protection  
Turn drum over, measure and mark the center of the bottom.  
Center the template on the bottom of the drum and secure  
with tape. Drill two 3/16" Funnel holes and three 5/16"  
Feeder Leg holes.  
Feeder Leg Holes  
Bolts  
Using a Hole Saw, drill a 2-1/4" hole in the center of the  
bottom of your drum.  
MOUNTING THE FEEDER  
Short  
Bolts  
Place Funnel inside Drum with  
small end of funnel facing down,  
and attach with two Short Bolts  
using nuts and washers provided.  
Drum  
Turn Drum upside down.  
Funnel  
Feeder  
Place Feeder on Drum.  
Attach Feeder Legs to Drum as  
Feeder Legs  
shown with Long Bolts using  
nuts and washers provided.  
Long  
Bolts  
Drum  
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed  
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if  
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference  
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the  
equipment off and on, the user is encouraged to correct the interference by one or more of the following measures:  
Reorient or relocate the receiving antenna Increase the separation between the equipment and the receiver  
 

Miele Ventilation Hood DA 216 2 User Manual
Multiquip Septic System MQ D206H User Manual
Napoleon Grills Gas Grill PTSS450RSB User Manual
NEC Clothes Dryer MD 15 User Manual
Nortel Networks Telephone P0919438 02 User Manual
Nvidia Computer Hardware FX 5900 XT User Manual
Olympus Camera Lens V312010BU000 User Manual
Orbit Manufacturing Outdoor Timer 57912 User Manual
Oricom Two Way Radio PMR888 User Manual
Panasonic Network Card 2SD1821G User Manual